TPS56628

SLVSC94 – OCTOBER 2013

www.ti.com

Power Good

The power-good function is activated after soft start has finished. The power good function becomes active after

1.7 times soft-start time. When the output voltage becomes within -10% of the target value, internal comparators

detect power good state and the power good signal becomes high. The power good output, PG is an open drain

output. If the feedback voltage goes under 15% of the target value, the power good signal becomes low. Rpg

resistor value, which is connected between PG and VREG5, is required from 25k

Ω to 150kΩ.

Current Protection

The output overcurrent protection (OCP) is implemented using a cycle-by-cycle valley detect control circuit. The

switch current is monitored by measuring the low-side FET switch voltage between the SW pin and GND. This

voltage is proportional to the switch current. To improve accuracy, the voltage sensing is temperature

compensated.

monitors the low-side FET switch voltage, which is proportional to the switch current, during the low-side on-time.

If the measured voltage is above the voltage proportional to the current limit, an internal counter is incremented

per each SW cycle and the converter maintains the low-side switch on until the measured voltage is below the

voltage corresponding to the current limit at which time the switching cycle is terminated and a new switching

cycle begins. In subsequent switching cycles, the on-time is set to a fixed value and the current is monitored in

the same manner. If the over current condition exists for 7 consecutive switching cycles, the internal OCL

threshold is set to a lower level, reducing the available output current. When a switching cycle occurs where the

switch current is not above the lower OCL threshold, the counter is reset and the OCL limit is returned to the

higher value.

There are some important considerations for this type of over-current protection. The load current one half of the

peak-to-peak inductor current is higher than the over-current threshold also when the current is being limited, the

output voltage tends to fall as the demanded load current may be higher than the current available from the

converter. This may cause the output voltage to fall. When the VFB voltage becomes lower than 65% of the

target voltage, the UVP comparator detects it. After 250 µs detecting the UVP voltage, device will shut down and

re-start after approximately 12ms hiccup time

When the over-current condition is removed, the output voltage returns to the regulated value.

Over Voltage Protection

TPS56628 detects over and under voltage conditions by monitoring the feedback voltage (VFB). This function is

enabled after approximately 1.7 x times the soft start time. When the feedback voltage becomes higher than

125% of the target voltage, the OVP comparator output goes high and both the high-side MOSFET driver and

the low-side MOSFET driver turn off. This function is non-latch operation.

UVLO Protection

Undervoltage lock out protection (UVLO) monitors the voltage of the VREG5 pin. When the VREG5 voltage is

lower than UVLO threshold voltage, the TPS56628 is shut off. This protection is non-latching.

Thermal Shutdown

TPS56628 monitors the temperature of itself. If the temperature exceeds the threshold value (typically 165°C),

the device is shut off. This is non-latch protection.

8

Copyright © 2013, Texas Instruments Incorporated

Product Folder Links :TPS56628