M24C64-RMB5TG/P
AI

The **M24C64-RMB5TG/P** is a specific variant of the M24C64 family, which are 64-Kbit I²C-compatible serial EEPROMs (Electrically Erasable Programmable Read-Only Memory). These devices are commonly used for non-volatile parameter storage in compact electronic devices.
---
## 1. Core Technical Specifications
The table below summarizes the primary electrical and physical characteristics of this part:
| Parameter | Specification |
| :--- | :--- |
| **Memory Size** | 64 Kbit (8,192 x 8 bits) |
| **Interface** | I²C (Two-Wire Serial) |
| **Operating Voltage ($V_{CC}$)** | 1.8V to 5.5V |
| **Clock Frequency** | 400 kHz (Fast Mode) / 1 MHz (Fast Mode Plus) |
| **Package Type** | UFDFPN8 (Ultra-thin Fine pitch Dual Flat No-lead) |
| **Operating Temperature** | -40°C to +85°C |
| **Data Retention** | 200 Years |
| **Endurance** | 4 Million Write Cycles |
---
## 2. Deciphering the Part Number
The suffix **"RMB5TG/P"** provides critical information about the packaging and environmental standards:
* **M24C64**: Device family (64 Kbit I²C EEPROM).
* **-R**: Operating voltage range (1.8V to 5.5V).
* **MB**: Package type (UFDFPN8, 2x3 mm).
* **5**: Device grade (Industrial temperature range -40°C to 85°C).
* **TG**: Tape and Reel packing.
* **P**: ECOPACK2 (RoHS compliant and Halogen-free).
---
## 3. Key Electronic Features
### I²C Interface Support
The device acts as a **slave** on the I²C bus. It uses a bidirectional Data line (SDA) and a Clock line (SCL). It supports multiple slave addresses, allowing several EEPROMs to be connected to the same bus using hardware address pins ($E_0, E_1, E_2$).
### Write Protection (WC Pin)
It features a hardware **Write Control (WC)** pin:
- If **WC is High**, the entire memory is write-protected (read-only mode).
- If **WC is Low**, the memory is unprotected and can be written to.
### Page Write Mode
Instead of writing one byte at a time, the device supports a **32-byte page write**. This significantly reduces the total time required to program the memory by allowing 32 bytes to be sent in a single burst before the internal write cycle begins (which takes roughly 5ms).
---
## 4. Typical Applications
* **Consumer Electronics:** Storing user settings in smartphones or cameras.
* **Industrial:** Storing calibration data and configuration parameters.
* **Medical:** Log data for portable diagnostic tools.
* **IoT Devices:** Storing Wi-Fi credentials and sensor thresholds.
- ⤷
What are the differences between M24C64 and M24C32 models?
- ⤷ How do I calculate the I2C slave address for this device?
- ⤷ What is the maximum internal write cycle time for this EEPROM?