Printed in USA

04/06

P/N 137372

Installing the Replacement Window

1. Remove all the screws and the bezel on the light (Figure 1).

2. Remove the existing window.

NOTE: You do not have to remove the o-ring unless it is damaged and needs to be

replaced. Replacement o-rings are available through Banner; see models

below. Be sure to remove any debris on the o-ring and the surrounding area

before installing the replacement window.

O-Ring Model

Area Light Housing

LEDA70SO

Nickel-plated aluminum

LEDA70SSO

Stainless steel

3. Remove the protective coverings from both sides of the window.

NOTE: Be careful not to touch the inside surface of the window; hold it by the edges

only. If necessary, clean the window using lens or window cleaner. For

Diffused Window models, place “frosted” (diffused) side of window against

o-ring.

4. Place the window onto the light, and secure with the screws and bezel. Tighten

screws so that there is no gap between the bezel and the light housing.

Banner Engineering Corp., 9714 Tenth Ave. No., Minneapolis, MN 55441 • Phone: 763.544.3164 • www.bannerengineering.com • Email: sensors@bannerengineering.com

Figure 1. Installing the replacement window on the light

For Use With Sealed High-Intensity Area Lights

LED..A70S Series Area Light Replacement Window Kits

Models

Clear Glass

Clear Acrylic

Clear

Diffusing Acrylic

White

Diffusing Acrylic

LEDA70SW-G

LEDA70SW-P

LEDA70SCDW-P

LEDA70SWDW-P