VL53L8CXV0GCSLASH1 datasheet(33/42 Pages) STMICROELECTRONICS

33 / 42 page

Packaging and labeling

9.1

Product marking

See the figure below for the product marking area. The marking is L8A-

Figure 30. Product marking area

A 2D product marking code is applied on the corner of the module cap as shown in Figure 31. 2D marking product

code.

Note:

The 2D marking code aligns with pin C7 of the module and is not an indicator of pin 1.

Figure 31. 2D marking product code

9.2

Inner box labeling

The labeling follows the Microelectronics' standard packing acceptance specification. The following information is

on the inner box label:

•

Assembly site

•

Sales type

•

Quantity

•

Trace code

•

Marking

•

Bulk ID number

9.3

Packing

At customer/subcontractor level, it is recommended to mount the VL53L8CX in a clean environment. To help

avoid any foreign material contamination at final assembly level, the modules are shipped in a tape and reel

format with a protective liner. The liner is compliant with reflow at 260°C (as per JEDEC-STD-020E).

Note:

The liner must be removed during assembly of the customer device, just before mounting the cover glass.

VL53L8CX

Packaging and labeling

DS14161 - Rev 2

page 33/42

VL53L8CXV0GC/1 Datasheet(PDF) 33 Page - STMicroelectronics