ST10F271 datasheet(44/173 Pages) STMICROELECTRONICS

Part #	ST10F271

Description	16-bit MCU with 128 Kbyte Flash memory and 12 Kbyte RAM

PDF	173 Pages

Scroll/Zoom	100%

Manufacturer	STMICROELECTRONICS [STMicroelectronics]

Direct Link	http://www.st.com

Logo

44 / 173 page

Bootstrap loader

ST10F271

44/173

6.3

Alternate and selective boot mode (ABM and SBM)

6.3.1

Activation of the ABM and SBM

Alternate boot is activated with the combination ‘01’ on Port0L[5..4] at the rising edge of

RSTIN.

6.3.2

User mode signature integrity check

The behavior of the Selective Boot Mode is based on the computing of a signature between

the content of 2 memory locations and a comparison with a reference signature. This

requires that users who use Selective Boot have reserved and programmed the Flash

memory locations.

6.3.3

Selective boot mode

When the user signature is not correct, instead of executing the Standard Bootstrap Loader

(triggered by P0L.4 low at reset), additional check is made.

Depending on the value at the User key location, following behavior will occur:

●

A jump is performed to the Standard Bootstrap Loader

●

Only UART is enabled for bootstraping

●

Only CAN1 is enabled for bootstraping

●

The device enters an infinite loop.

ST10F271 Datasheet(PDF) 44 Page - STMicroelectronics