Data Sheet

ADP150

SPECIFICATIONS

analog.com

Rev. E | 4 of 20

Table 1. (Continued)

Parameter

Symbol

Test Conditions/Comments

Min

Typ

Max

Unit

EN Input Leakage Current

VI-LEAKAGE

EN = IN or GND

0.001

µA

EN = IN or GND, TJ = −40°C to +125°C

1

µA

OUTPUT NOISE

OUTNOISE

10 Hz to 100 kHz, VIN = 5 V, VOUT = 3.3 V

9

µV rms

10 Hz to 100 kHz, VIN = 5 V, VOUT = 2.5 V

9

µV rms

10 Hz to 100 kHz, VIN = 5 V, VOUT = 1.8 V

9

µV rms

POWER SUPPLY REJECTION RATIO

PSRR

10 kHz, VIN = 3.8 V, VOUT = 3.3 V, IOUT = 10 mA

70

dB

(VIN = VOUT + 0.5 V)

10 kHz, VIN = 2.3 V, VOUT = 1.8 V, IOUT = 10 mA

70

dB

100 kHz, VIN = 3.8 V, VOUT = 3.3 V, IOUT = 10 mA

55

dB

100 kHz, VIN = 2.3 V, VOUT = 1.8 V, IOUT = 10 mA

55

dB

POWER SUPPLY REJECTION RATIO

10 kHz, VIN = 4.3 V, VOUT = 3.3 V, IOUT = 10 mA

70

dB

(VIN = VOUT + 1 V)

100 kHz, VIN = 4.3 V, VOUT = 3.3 V, IOUT = 10 mA

55

dB

1 Based on an end-point calculation using 1 mA and 150 mA loads. See Figure 6 for typical load regulation performance for loads less than 1 mA.

2 Dropout voltage is defined as the input-to-output voltage differential when the input voltage is set to the nominal output voltage. This applies only for output voltages above

2.2 V.

3 Start-up time is defined as the time between the rising edges of EN to VOUT being at 90% of its nominal value.

4 Current limit threshold is defined as the current at which the output voltage drops to 90% of the specified typical value. For example, the current limit for a 3.0 V output

voltage is defined as the current that causes the output voltage to drop to 90% of 3.0 V or 2.7 V.

RECOMMENDED SPECIFICATIONS: INPUT AND OUTPUT CAPACITOR

Table 2.

Parameter

Symbol

Test Conditions/Comments

Min

Typ

Max

Unit

INPUT AND OUTPUT CAPACITOR

Minimum Input and Output Capacitance1

CMIN

TA = −40°C to +125°C

0.7

µF

Capacitor ESR

RESR

TA = −40°C to +125°C

0.001

0.2

Ω

1 The minimum input and output capacitance should be greater than 0.7 µF over the full range of operating conditions. The full range of operating conditions in the

application must be considered during device selection to ensure that the minimum capacitance specification is met. X7R-type and X5R-type capacitors are recommended,

and Y5V and Z5U capacitors are not recommended for use with any LDO.