AD2S83IP datasheet(11/19 Pages) AD

11 / 19 page

AD2S83

–11–

REV. D

DIRECTION Output

The DIRECTION (DIR) output indicates the direction of the

input rotation. Any change in the state of DIR precedes the

corresponding BUSY, DATA and RIPPLE CLOCK updates.

DIR can be considered as an asynchronous output and can

make multiple changes in state between two consecutive LSB

update cycles. This occurs when the direction of rotation of the

input changes but the magnitude of the rotation is less than 1 LSB.

COMPLEMENT

The

COMPLEMENT input is an active low input and is inter-

nally pulled to +VS via 100 k

Ω.

Strobing

DATA LOAD and COMPLEMENT pins to logic LO

will set the logic HI bits of the AD2S83 counter to a LO state.

Those bits of the applied data which are logic LO will not

change the corresponding bits in the AD2S83 counter.

For Example:

Initial Counter State

1 0 1 0 1

Applied Data Word

1 1 0 0 0

Counter State after

DATA LOAD

1 1 0 0 0

Initial Counter State

1 0 1 0 1

Applied Data Word

1 1 0 0 0

Counter State after

DATA LOAD and Complement

0 0 1 0 1

In order to read the counter following a

DATA LOAD, the

procedure below should be followed:

1. Place outputs in high impedance state (

ENABLE = HI).

2. Present data to pins.

3. Pull

DATA LOAD and COMPLEMENT pins to ground.

4. Wait 100 ns.

5. Remove data from pins.

6. Remove outputs from high impedance state (

ENABLE =

LO).

7. Read outputs.

CIRCUIT FUNCTIONS AND DYNAMIC PERFORMANCE

The AD2S83 allows the user great flexibility in choosing the

dynamic characteristics of the resolver-to-digital conversion to

ensure the optimum system performance. The characteristics

are set by the external components shown in Figure 1. The

Component Selection section explains how to select desired

maximum tracking rate and bandwidth values. The following

paragraphs explain in greater detail the circuit of the AD2S83

and the variations in the dynamic performance available to the

user.

Loop Compensation

The AD2S83 (connected as shown in Figure 1) operates as a

Type 2 tracking servo loop where the VCO/counter combination

and Integrator perform the two integration functions inherent in

a Type 2 loop.

Additional compensation in the form of a pole/zero pair is re-

quired to stabilize the loop.

This compensation is implemented by the integrator compo-

nents (R4, C4, R5, C5).

The overall response the converter is that of a unity gain second

order low-pass filter, with the angle of the resolver as the input

and the digital position data as the output.

The AD2S83 does not have to be connected as tracking con-

verter, parts of the circuit can be used independently. This is

particularly true of the Ratio Multiplier which can be used as a

control transformer. (For more information contact Motion

Control Applications.)

A block diagram of the AD2S83 is given in Figure 4.

RATIO

MULTIPLIER

VCO

PHASE

SENSITIVE

DEMODULATOR

AC ERROR

A, SIN ( – ) SIN

SIN

COS

SIN

DIGITAL

CLOCK

DIRECTION

VELOCITY

INTEGRATOR

Figure 4. Functional Diagram

AD2S83IP Datasheet(PDF) 11 Page - Analog Devices

AD2S83IP Datasheet(HTML) 11 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19

Datasheet Download

Link URL