LQFP64 datasheet(55/103 Pages) STMICROELECTRONICS

55 / 103 page

SPC560P34L1, SPC560P34L3, SPC560P40L1, SPC560P40L3

Electrical characteristics

Doc ID 16100 Rev 7

55/103

Note:

The voltage regulator output cannot be used to drive external circuits. Output pins are to be

used only for decoupling capacitance.

VDD_LV_COR must be generated using internal regulator and external NPN transistor. It is

not possible to provide VDD_LV_COR through external regulator.

For the SPC560P34/SPC560P40 microcontroller, capacitor(s), with total values not below

CDEC1, should be placed between VDD_LV_CORx/VSS_LV_CORx close to external ballast

transistor emitter. 4 capacitors, with total values not below CDEC2, should be placed close to

microcontroller pins between each VDD_LV_CORx/VSS_LV_CORx supply pairs and the

VDD_LV_REGCOR/VSS_LV_REGCOR pair . Additionally, capacitor(s) with total values not below

CDEC3, should be placed between the VDD_HV_REG/VSS_HV_REG pins close to ballast

collector. Capacitors values have to take into account capacitor accuracy, aging and

variation versus temperature.

All reported information are valid for voltage and temperature ranges described in

recommended operating condition, Table 10 and Table 11.

Figure 10.

Voltage regulator configuration

BCTRL

VDD_LV_COR

CDEC3

CDEC2

CDEC1

VDD_HV_REG

BJT(1)

SPC560P34/SPC560P

Refer to Table 15.

Table 15.

Approved NPN ballast components

Part

Manufacturer

Approved derivatives(1)

BCP68

ON Semi

BCP68

NXP

BCP68-25

Infineon

BCP68-25

BCX68

Infineon

BCX68-10; BCX68-16; BCX-25

BC868

NXP

BC868

LQFP64 Datasheet(PDF) 55 Page - STMicroelectronics

LQFP64 Datasheet(HTML) 55 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL