| Electronic Components Datasheet Search |
|
H8S/2426R Datasheet(PDF) 1111 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
H8S/2426R Datasheet(HTML) 1111 Page - Renesas Technology Corp |
|
1111 / 1302 page ![]() Section 21 Flash Memory Rev. 1.00 Sep. 19, 2008 Page 1083 of 1270 REJ09B0466-0100 (9) Programming/Erasing State A programming selection command makes the boot program select the programming method, an 128-byte programming command makes it program the memory with data, and an erasing selection command and block erasing command make it erase the block. The programming/erasing commands are listed below. Table 21.9 Programming/Erasing Commands Command Command Name Description H'43 User MAT programming selection Transfers the user MAT programming program H'50 128-byte programming Programs 128 bytes of data H'48 Erasing selection Transfers the erasing program H'58 Block erasing Erases a block of data H'52 Memory read Reads the contents of memory H'4B User MAT sum check Checks the checksum of the user MAT H'4D User MAT blank check Checks whether the contents of the user MAT are blank H'4F Boot program status inquiry Inquires into the boot program’s status • Programming Programming is executed by a programming-selection command and a 128-byte programming command. Firstly, the host should send the programming-selection command and select the programming method and programming MATs. The programming selection command is user MAT programming selection, regardless of the area and method for programming. After issuing the programming selection command, the host should send the 128-byte programming command. The 128-byte programming command that follows the selection command represents the data programmed according to the method specified by the selection command. When more than 128-byte data is programmed, 128-byte commands should repeatedly be executed. Sending a 128-byte programming command with H'FFFFFFFF as the address will stop the programming. On completion of programming, the boot program will wait for selection of programming or erasing. Where the sequence of programming operations that is executed includes programming with another method or of another MAT, the procedure must be repeated from the programming selection command. |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |