MFSYS35 datasheet(14/52 Pages) INTEL

14 / 52 page

System Overview

Intel® Modular Server System MFSYS25/MFSYS35 TPS

See Section 3.6 for a description of this module.

2.3.2.2

Storage Controller Module

The chassis can accommodate up to two hot-swap storage controller modules to support the

external hard disks in the front storage enclosure. One storage controller is the minimum

configuration, with a second storage controller allowing storage controller redundancy. Storage

controller failures are automatically detected and hard drive access is maintained through the

operational storage controller.

See Section 3.7 for a description of this system.

2.3.3

Chassis Management Module

The chassis management module, installed in the middle-rear of the chassis amid the four I/O

slots, provides an Internet browser interface that allows for configuration and management of

the entire Intel

® Modular Server System MFSYS25/MFSYS35. This module is not redundant,

but the system continues to operate normally should this module fail although any changes to

the system configuration cannot be made until the failed chassis management module is

replaced.

See Section 3.5 for a description of this module.

2.3.4

Main Cooling Module

Two hot-swap cooling modules are installed on the left rear of the chassis. Each cooling module

contains two redundant fans that operate in a (1+1) cooling redundancy. Cooling module 1

cools compute modules 1-3; cooling module 2 cools compute modules 4-6.

2.4

Internal Chassis Features

The following figures provide an internal view of how the Intel

® Modular Server System

MFSYS25/MFSYS35

system boards are connected.

Revision 1.3

Intel order number E15155-005

MFSYS35 Datasheet(PDF) 14 Page - Intel Corporation