| Electronic Components Datasheet Search |
|
LQFP176 Datasheet(PDF) 86 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
LQFP176 Datasheet(HTML) 86 Page - STMicroelectronics |
|
86 / 133 page ![]() Electrical characteristics SPC560B54x/6x 86/133 DocID15131 Rev 9 4.10.3 Start-up/Switch-off timings 4.11 Electromagnetic compatibility (EMC) characteristics Susceptibility tests are performed on a sample basis during product characterization. 4.11.1 Designing hardened software to avoid noise problems EMC characterization and optimization are performed at component level with a typical application environment and simplified MCU software. It should be noted that good EMC performance is highly dependent on the user application and the software in particular. Table 32. Flash power supply DC electrical characteristics Symbol Parameter Conditions(1) Value Unit Min Typ Max ICFREAD CC Sum of the current consumption on VDD_HV and VDD_BV on read access Flash module read fCPU = 64 MHz Code Flash — — 33 mA IDFREAD Data Flash — — 33 ICFMOD CC Sum of the current consumption on VDD_HV and VDD_BV on matrix modification (program/erase) Program/Erase on-going while reading Flash registers fCPU = 64 MHz Code Flash — — 52 mA IDFMOD Data Flash — — 33 ICFLPW CC Sum of the current consumption on VDD_HV and VDD_BV during Flash low power mode — Code Flash — — 1.1 mA IDFLPW Data Flash — — 900 µA ICFPWD CC Sum of the current consumption on VDD_HV and VDD_BV during Flash power down mode — Code Flash — — 150 µA IDFPWD Data Flash — — 150 1. VDD = 3.3 V ± 10% / 5.0 V ± 10%, TA = –40 to 125 °C, unless otherwise specified. Table 33. Start-up time/Switch-off time Symbol C Parameter Conditions(1) Value Unit Min Typ Max tFLARSTEXIT CC T Delay for Flash module to exit reset mode — — — 125 µs tFLALPEXIT CC T Delay for Flash module to exit low-power mode — — — 0.5 tFLAPDEXIT CC T Delay for Flash module to exit power-down mode — — — 30 tFLALPENTRY CC T Delay for Flash module to enter low-power mode — — — 0.5 tFLAPDENTRY CC T Delay for Flash module to enter power-down mode — — — 1.5 1. VDD = 3.3 V ± 10% / 5.0 V ± 10%, TA = 40 to 125 °C, unless otherwise specified. |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |