LQFP64 datasheet(10/90 Pages) STMICROELECTRONICS

10 / 90 page

Block diagram

SPC560D30x, SPC56040Dx

10/90

Doc ID 16315 Rev 7

Table 3 summarizes the functions of all blocks present in the Pictus 512K series of

microcontrollers. Please note that the presence and number of blocks varies by device and

package.

Table 3.

Pictus 512K series block summary

Block

Function

Analog-to-digital converter (ADC) Multi-channel, 12-bit analog-to-digital converter

Boot assist module (BAM)

A block of read-only memory containing VLE code which is executed according

to the boot mode of the device

Clock generation module

(MC_CGM)

Provides logic and control required for the generation of system and peripheral

clocks

Clock monitor unit (CMU)

Monitors clock source (internal and external) integrity

Cross triggering unit (CTU)

Enables synchronization of ADC conversions with a timer event from the eMIOS

or from the PIT

Crossbar switch (XBAR)

Supports simultaneous connections between two master ports and three slave

ports. The crossbar supports a 32-bit address bus width and a 64-bit data bus

width.

Deserial serial peripheral

interface (DSPI)

Provides a synchronous serial interface for communication with external

devices

Enhanced direct memory access

(eDMA)

Performs complex data transfers with minimal intervention from a host

processor via “n” programmable channels.

Enhanced modular input output

system (eMIOS)

Provides the functionality to generate or measure events

Error correction status module

(ECSM)

Provides a myriad of miscellaneous control functions for the device including

program-visible information about configuration and revision levels, a reset

status register, wakeup control for exiting sleep modes, and optional features

such as information on memory errors reported by error-correcting codes

Flash memory

Provides non-volatile storage for program code, constants and variables

FlexCAN (controller area

network)

Supports the standard CAN communications protocol

Frequency-modulated phase-

locked loop (FMPLL)

Generates high-speed system clocks and supports programmable frequency

modulation

Internal multiplexer (IMUX) SIU

subblock

Allows flexible mapping of peripheral interface on the different pins of the device

Interrupt controller (INTC)

Provides priority-based preemptive scheduling of interrupt requests

JTAG controller (JTAGC)

Provides the means to test chip functionality and connectivity while remaining

transparent to system logic when not in test mode

LINFlex controller

Manages a high number of LIN (Local Interconnect Network protocol)

messages efficiently with a minimum of CPU load

Mode entry module (MC_ME)

Provides a mechanism for controlling the device operational mode and mode

transition sequences in all functional states; also manages the power control

unit, reset generation module and clock generation module, and holds the

configuration, control and status registers accessible for applications

Non-maskable interrupt (NMI)

Handles external events that must produce an immediate response, such as

power down detection

LQFP64 Datasheet(PDF) 10 Page - STMicroelectronics

LQFP64 Datasheet(HTML) 10 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90

Datasheet Download

Link URL