PCF5271CVM100 datasheet(11/56 Pages) FREESCALE

11 / 56 page

Features

MCF5271 Integrated Microprocessor Hardware Specification, Rev. 1.2

Freescale Semiconductor

and UARTs. The DMA controller supports single or dual address to off-chip devices or dual address to

on-chip devices.

3.17 External Interface Module (EIM)

The external bus interface handles the transfer of information between the core and memory, peripherals,

or other processing elements in the external address space. Features have been added to support external

Flash modules, for secondary wait states on reads and writes, and a signal to support Active-Low Address

Valid (a signal on most Flash memories).

Programmable chip-select outputs provide signals to enable external memory and peripheral circuits,

providing all handshaking and timing signals for automatic wait-state insertion and data bus sizing.

Base memory address and block size are programmable, with some restrictions. For example, the starting

address must be on a boundary that is a multiple of the block size. Each chip select can be configured to

provide read and write enable signals suitable for use with most popular static RAMs and peripherals. Data

bus width (8-bit, 16-bit, or 32-bit) is programmable on all chip selects, and further decoding is available

for protection from user mode access or read-only access.

3.18 SDRAM Controller

The SDRAM controller provides all required signals for glueless interfacing to a variety of

JEDEC-compliant SDRAM devices. SD_SRAS/SD_SCAS address multiplexing is software configurable

for different page sizes. To maintain refresh capability without conflicting with concurrent accesses on the

address and data buses, SD_RAS, SD_SCAS, SD_WE, SD_CS[1:0] and SD_CKE are dedicated SDRAM

signals.

3.19 Reset

The reset controller is provided to determine the cause of reset, assert the appropriate reset signals to the

system, and keep track of what caused the last reset. The power management registers for the internal

low-voltage detect (LVD) circuit are implemented in the reset module. There are six sources of reset:

•

External

•

Power-on reset (POR)

•

Watchdog timer

•

Phase locked-loop (PLL) loss of lock

•

PLL loss of clock

•

Software

External reset on the RSTOUT pin is software-assertable independent of chip reset state. There are also

software-readable status flags indicating the cause of the last reset.

PCF5271CVM100 Datasheet(PDF) 11 Page - Freescale Semiconductor, Inc